Recent content by low wong

My Quest 451 equipped with KS REFOCUS more than 8 months, with LOCKOUT function. Love it.

Not yet finished. Not yet finished.

Hi boddhi, My Quest has Hi boddhi, My Quest has smaller diameter sliding tube then yours, may be difference generation.

Hi dave, thanks for your hard Hi dave, thanks for your hard work's sharing, especially the 2nd picture solve my Quest trouble too. I have a question: Which kind of shim (rubber, aluminium,etc) you use for the upper tube's clamp?

Hi, SKS rear mudguard with Hi, SKS rear mudguard with long stay for Quest rear wheel, another Dahon rear mudguard for front wheel, that's my solution.

(No subject)

Shorten the clamps . Shorten the clamps .

(No subject)

For Charles: The For Charles: The inside dimensions of the case : 27cm, 58cm, 63cm. The Brompton suitcase is a big box. For Kungfugy : The helmet came from Japan, see RIN PROJECT. And "Why the mask?", for 2 reasons, 1, I still feel little uneasy with my Quest stop before the RED...

Hi Charles, I don’t have Hi Charles, I don't have Samsonite , but I have a suitcase for Brompton. Once I pack my Quest into the Brompton suitcase, I would like to post a photo on this page. Cheers, Vovolc

longer chainstay is a good for me!

Congratulations? Covered Congratulations? Covered whole island. Bravo!

Good news! Good news!

I replaced a non threaded I replaced a non threaded bolt for my quick release but still shouting, then I try to adjust the spring shock, after several testing, finally, the noise was eliminated! I think I just tightened the loosing part.

Thanks for your sharing, Thanks for your sharing, about this noise, you finally found the solution and I still focus on the shock! I will try to get a non threaded bolt to end up my trouble.