Recent content by Romagjack

Agfrag, there is zero drag from motor as it is a geared motor as opposed to direct drive. The battery and motor add about 13 lbs. to the bike so I generally compensate by using the throttle along with pedal power when climbing hills, but the added weight of the bike is an advantage when...

Agfrag, I went with a 203mm but could have gone smaller. I think the 160mm should be fine as the motor is quite small. The power cable from the motor actually comes out of the axle and I was able to run the cable on the inside of the rear frame - very stealthy and you have to look hard to tell...

I just installed a Hilltopper Sprinter Kit on my Q-559 as I’m getting older and dead starts and hills were becoming an issue. I’ve always liked the dual suspension and the Sram Dual Drive on the Q. I put the variable speed thumb throttle on the left handlebar where I can use it in conjunction...

Anyone looking at the new Hilltopper Sprinter kit: https://hilltopperbikes.com/product-category/electric-bike-kits/ 250 watt motor, throttle, and small water bottle type battery that could fit on the seat back. This might be perfect for starting from a dead stop or use on steep hills.

I contacted Electric Bike Solutions and was told the 36v smaller kit with 350 w motor would work with the 52v Luna Wolf Pup battery with some modifications. I will do a little more research but that was good news.

Ok, I'm ready to electrify my Quest. But, all I really need assist for is starting from a dead stop at stop signs (just enough to get my feet comfortably "clipped" onto the pedals, slow tight turns, and an occasional hill assist. I wouldn't even need the PAS. I could probably get by with a 250 w...

Thanks. I can see by your picture that you are a mile away from the ground on your V.

I can't seem to get a measurement from the top of the Pletcher Two Leg Kickstand to the ground. It looks like the Quest needs a kickstand that would be at least 14 inches from the bottom of the kickstand bracket straight to the ground. So, with the angle of the legs, that would add length to the...

Too bad, I was hoping to stabilize the bike better in this position. Any ideas?

Friscard, regarding that bike stand, would it work with the front wheel at a right angle with the wheel turned to the left (the bike in an "L" position)? I want to store the bike in a corner of the garage but have limited space.

Nice bike. May I ask what dual kickstand that is, do you like it, and does it work well with your set up? Do you think it would work with the Quest?

Yes, I see where the geared motor is better for freewheeling. I like your setup. Wonder if there would be room in the slingbag (or if a similar bag) for the battery, wires and controller? It would be nice to keep all that weight low. I could get by with a smaller battery if it would fit. With...

That may be the ticket - if the legs are long enough. If the legs are too long, one could always cut them back.

Thanks, I realize that, but I still need to put a 2 x 4 under it to gain some stability in my garage. Wish I could find a kickstand a few inches longer with a bigger foot.

Anyone found a way to extend the stock kickstand on a Q559 or a good alternative? Stock kickstand is just too short and I can only get the bike to stand when the front wheel is fully turned to the right side.