Recent content by RoyR

  1. R

    Learning to ride again...

    Making progress learning to ride my new Quest, but I'm not quite there yet. I seem to still be fighting the bike. Yesterday I noticed that I had twisted the handlebar out of alignment with the front wheel somehow ( I did not crash). The bar is tight and I know I mounted it properly. I...
  2. R

    New homemade fairing for Quest

    That's an amazing piece of That's an amazing piece of work! Great job! How much weight do the fairing and brackets add? --Roy
  3. R

    Checkup at bike shop every 50 hours??

    Motorcyclist here as well.  I Motorcyclist here as well. I am a fanatic about tire pressure, brakes, and chain care, among the other chores. Risk-management is very important on two wheels, motor or not!
  4. R

    Correct way to assemble seat-pan and seat-back interface

    1. It looks like the correct way to connect the seat back and seat pan is as follows: From the back of the seat pan...Allen bolt head, washer, seat back, grommet, seat pan, washer, knob. Right? I ask the question because Item 12 of the instructions says that the grommet goes between...
  5. R

    Two split-rubber tubes labelled "Jagwire"

    What are these two little split-rubber tubes used for? Some kind of cable boots?
  6. R

    Checkup at bike shop every 50 hours??

    Just about finished with Just about finished with assembly. Still need to set up the brakes. Minimal problems, but instructions could be improved here and there. Perhaps I'll send a few suggestions to Cruzbike. Now that I'm more familiar with the bike and after seeing the robust build...
  7. R

    Checkup at bike shop every 50 hours??

    Good day to all. Q559 delivered to me late yesterday and ready for assembly today! A quick question on maintenance and reliability. I was rather surprised that item 6 on page 25 of the owner's manual recommends taking the bike to a dealer for a "complete checkup" after every 50 hours of...
  8. R

    Gear-inch range on Quest v3

    Hey...newbie here...considering buying the Quest... What is the gear-inch range for the Quest version 3, for both wheel sizes? I can't figure it out since I don't know the data on the internal hub's gearing, or how to apply it to the gear calculation. Perhaps someone here has generated an...
  9. R

    2 Cruzbike Quests for sale

    I realize my question is not I realize my question is not related to your sale but I wanted to ask how much the maximum total weight was that you carried on your tours (rider plus all gear)? thanks! --Roy
Top