Search results

On my V20 I use a Moose Pack so the rear brake is on the upper mount point. The tip of the pivot arm is unfortunately very close to the frame. While the brake arm does not touch the frame there is no room to use a ferrel on the cable housing so that it will fit into the brake arm. Since...

My Ventisit Comfort Cushion uses two Velco Strips down the middle to hold the cushion in place. The 3cm x 13cm cushion side strips have the "loops" and the cooresponding seat side have the "hooks. When riding the strips are not enough to prevent lateral movement of the cushion. Out of...

An El Paso Bicycle Club annual event. http://www.elpasobicycleclub.com/cpc/ There were about 900 riders signed up for this event. Our group of about 200 strong arrived to partly cloudy skies and a north wind about 8-10 mph for the 62 mile ride starting at 7:30AM. Temperature was about 58F...

I will be riding the Red Vendetta on the 100K route for my initiation. We shall see how this goes. http://www.elpasobicycleclub.com/cpc/index.html

Time will tell if these will be practical on our bikes? https://www.nikonusa.com/en/nikon-products/action-cameras/index.page https://360fly.com

The BentUp Cycles Aero Bag is designed to slip over the back of a hard shell seat. On the Vendetta 20, the bag is not compatible with the seat and headrest as is. Here is one more way of adapting the headrest bar to carry the bag. Headrest Cage Mount Kit from CruzBike. Headrest Mount...

Has anyone converted the Cruzbike A67 wheel to be used with tubeless tires?

Last Friday I received the new Headrest Cage Mount Kit from Cruzbike. I moved the two cages under the carbon seat to the new kit. Nice setup! I have had a BentUp Aero bag for a while but hadn't found a satisfactory way to mount it on the V20 neck rest . Because I am short the headrest is...

Eric Winn discussed using only Velcro for attaching the seat to the frame during his May 2013 Vendetta build. Are there others using only Velcro to hold the carbon seat to the frame on the later generations of Vendetta and Silvio? Likes or dislikes?

On Nov. 7 the new V20 frame set unexpectedly arrived much to my surprise. Better than Nov. 30 or later. The delivery came in two packages, the frame itself and the handlebar. All in good condition. I will build up the V20 using most of the components from my Silvio 1.0. A delivery of...

In the Vendetta Forum I have a problem with the following thread: "Transporting a Vendetta" The 1st post is 12-26-13 and last post is 12-31-13. This thread repeatedly reappears with a notification of a new post but there is no new post. The last post is still dated 12-31-13...

Three years nine months and 3540 miles the engine for the Silvio was finally ready to tackle Loop 375-Woodrow Bean Transmountain Road and climb to the top of Smugglers Pass. Ride began a little after 6:00 AM today. The weather was cool early and there was no wind. GPS map which covers...

NeverReach Nefron, How did you attach the Never Reach to the Silvio? Bruce B