Neck rest tubes to Seat clamps 3D printed

[Andrew Wilson]

I know it's not necessary but I wanted clamps in case I forgot and grabbed the top of the seat. I didnt want to restrict adjusting the neck rest so I made them to snap over the tubes but leave clearance for the tubes to slide.
It really adds a nice amount of support in case I grab the seat to lift instead of the neck rest.

 

[jond]

Nice job.

The bike would have originally come with round clamps for same purpose of clamping seat and not relying solely on Velcro.

Both mine did.

 

[DavidCH]

You might want to put some black silicon sealant between the neck rest support tubes and the bike frame. Stops sweat and rain from getting into the hollow frame. Earlier Vs had this feature.

 

[Andrew Wilson]

Thanks JD and David.
Mine didnt have the clamps and they are no longer available from Cruzbike. Plus gives me an excuse to make something
Once I get the fit dialed in I'll seal the area. Thanks for the tip.