Can't get into lowest gear (Q45) question

[jeffssmith1]

The derailleur pulley is bumping into the largest cog. My Q45 has the microshift XLE derailleur and the b-screw is screwed all the way in.

Should I get a longer b-screw to push it further out so it doesn't bump into the biggest cog (lowest gear)?

It will get into that gear once in a while, both most of the time the chain won't jump to the biggest cog of the cassette.

 

[kizarmynot]

To make sure we’re talking about the same thing, the b-screw adjusts the gap between the pulley and the cassette, while the high and low limit screws adjust the max travel inboard and outboard. It looks like Microshift has videos on their website, but another great resource is ParkTool
Good luck

 

[jeffssmith1]

To make sure we’re talking about the same thing, the b-screw adjusts the gap between the pulley and the cassette, while the high and low limit screws adjust the max travel inboard and outboard. It looks like Microshift has videos on their website, but another great resource is ParkTool
Good luck

Yes, that is the screw. Thanks.

 

[Greg S]

If the upper jockey wheel is hitting the biggest cog either the B-stay screw needs to be screwed in further (most likely) or possibly the chain is too short. What size cassette are you using? Is it within spec for the microshift derailleur (42 tooth)?

 

[jeffssmith1]

I have the stock 42 tooth. My B screw is screwed all the way in. I think I'll buy a longer B screw and see if that fixes the problem.

 

[jeffssmith1]

A longer B screw didn't help. Perhaps I need a Microshift 11-40T cassette (instead of the stock 11-42T).