Carry rack for a CB

[Bhride]

I'm looking for a rack for my truck to carry two bikes one being a CB. I have searched the forum for any info on this subject but came up empty.
I don't want to buy any ole rack not knowing if it will handle a Cruzbike. So does anyone have suggestions on this subject? Appreciate the help if you do.
Thanks

 

[Always-Learnin]

QuikrStuff - Proudly made in the USA

QuikrStuff - Home of the Quik Rack Mach2 Bicycle Rack

quikrstuff.com

I carry all my Cruzbikes using this rack. Expensive but you get what you pay for...

 

[Cyclechik]

I have a Kuat Sherpa 2 and I can carry my S40 and my spouse's DF with no problem. I have to put the S40 on first so I can tilt it away from the hook enough to get the hook between the boom and the tire, but it's no hassle.

 

[Bhride]

Thanks guys, I'll look them up.

 

[Cyclechik]

Shoulda sent this earlier. Kinda hard to see…

 

[Greg S]

I'm looking for a rack for my truck to carry two bikes one being a CB. I have searched the forum for any info on this subject but came up empty.
I don't want to buy any ole rack not knowing if it will handle a Cruzbike. So does anyone have suggestions on this subject? Appreciate the help if you do.
Thanks

Likewise on the Kuat Sherpa. Two recumbents (1 Cruzbike, 1 high racer) no problem. Also One recumbent, one DF, no problem.

 

[Mathew Fy]

Some opinions:

Car rack solution

Hi every one, I am looking into the perfect way to bring my v20 with me. I have a temporary bike rack that I can put on my trunk but I chipped the paint of my vendetta last year while there was a second bike. It is also hard to stabilized the front wheel. Do you have any recommandation for a set...

forum.cruzbike.com

1up Quik Rack Guidance: Arm Over Front Wheel?

Can someone post of photo of their quikrack from 1up going over the front wheel, if you actually cut the arm down to size to fit under the bottom bracket? What did you cut it with and do you regret it.

forum.cruzbike.com

Preferred method to transport your Cruzbike?

I'm guessing hitch rack is the #1 response...followed by roof rack. I've got a Saris Bones trunk rack & no hitch on my vehicle. I suspect it won't do the as the supports are too close to work with any Cruzbike frame...but I'm just guesstimating based on listed frame geometry and calculated...

forum.cruzbike.com

Suggestions for a new bike carrier

I've been using a Swagman XC2 hitch-mount bike carrier to transport a Silvio and a Q on a Honda Accord. It uses hooks on a ratcheting bar to hold the bikes by the frame. I had been thinking about upgrading anyway, but my Honda dealer's service department has made that decision more immediate...

forum.cruzbike.com

 

[Bhride]

QuikrStuff - Proudly made in the USA

QuikrStuff - Home of the Quik Rack Mach2 Bicycle Rack

quikrstuff.com

I carry all my Cruzbikes using this rack. Expensive but you get what you pay for...

Hi Matt, I was wondering if the Quikr rack will work should you have a carry rack on the back of CB. I have a Q 45

 

[Mathew Fy]

Hi Matt, I was wondering if the Quikr rack will work should you have a carry rack on the back of CB. I have a Q 45

This style rack’s swing arms work well with my S40 with its rack, so it’ll probably work for you.

 

[YOGA_O]

I use this Yakima two-bike carrier. I found the QuikrStuff wouldn't work with my son's bike (fenders). I find it better with my S40 in the position farthest away from the car.

 

[Mike Cassera]

I use this for my S40 and my wife's Ebike.

 

[Bhride]

I use this for my S40 and my wife's Ebike.

I have a Q45 but I'm sure there will not be much difference, what does the vertical clamp grab unto?

 

[Mike Cassera]

I have a Q45 but I'm sure there will not be much difference, what does the vertical clamp grab unto?

The vertical bar that holds the clamp is pivoted at the bottom so it can swing 90 degrees left or right covering 180 degrees. The clamp can move along the entire bar so you can attach the clamp to almost any point on a bike. It's a very flexible arrangement. It only comes for a 2 inch hitch but I used an adapter for my 1 1/4. It's rock solid and I paid less than $400 on Amazon.

 

[LazarGator]

A few different ways to load and secure an S40 on a RockyMounts Monorail hitch rack. Using the swing arm on the frame in front of the seat seems most stable and easiest/quickest to secure. Good luck in finding what works for you, lots of options.

 

[orind]

I modified my 1-up rack a touch--works well. Just move the spacer down on one side and trim the arms.