Search results

It sounds like the front DR has a low limit screw that is pushing the chain over too far causing it to over-shift the small ring. This chain guard from K-Edge might work well - it would mimic the type of guard that is built into the SRAM FD's...

I think that the CF front is notably calmer on rough surfaces like bad chip seal, for example.

The front CF parts of the V20C are very very tough structurally - trust me. I tried very hard to shatter a boom and slider back when we were doing the samples by hitting them against metal surfaces like they were baseball bats. No shatters. They are also lighter than the aluminum fronts and...

Hub widths are standard 100mm (front hub width) for our rear wheel, 142mm rear hub width for the drive wheel. Through axles are 12mm - our axle for the front fork is longer than a standard through axle though because of the need to pass through the stays - but in any conversion you would be...

Send an email to Katie at support@cruzbike.com we have the washers. :emoji_thumbsup:

Check for the washers on the pivot clamp bolt, and make sure that sleeve is greased. This is in my experience the most common area for creaking where the washers are not correct:

That should not be a problem at all. In fact that used to be the size before. Robert

The end is a T40? Hmm I haven't seen that. I heave only ever seen the regular 6mm Allen version.

We do have those :-) its a combo 6mm Allen/T25 for the rotors and caliper bolts

Hey there - if you send an email to Katie at the support@cruzbike.com email she can set you up with a new hanger and invoice you for one easily - we have those in stock they just aren't listed on the site. Robert

If you get hold of Bart at Ventist I imagine he can make one the exact size you need if he doesn't have some around that would work. He is awesome.

Very nice. Fun fact - the curvature of our adjustable CF seat was modeled after that seat (with some tweaks)

Hmmm... I am a bit shocked (lol) that you would have so much sag with that psi - that said the replacements will be internal dampened (like the original versions we used to put on the Q's but a better quality version) and 1000lb - not a 1200lb like the stock external coil shock. The much older Q...

Indeed - the stock S40 and V20C bar is a wider version (2cm wider) of the Salsa Woodchipper 2. Any road bar with a 31.8 clamp area will work. There are a million bars through so it is impossible for us to even rationalize stocking any. The stock bar is very wide - probably too wide - for most...

Thats old school cool right there.

WIN!!!!!

With their adapter (SRAM 8 bolt) like the link below nearly any stock rings can be used: https://www.crodercycling.com/products/spirit-spider-5-arm They also have doubles: https://www.crodercycling.com/products/gearmate-chainring-standard-5-arm They have a 46/30 even.

When in doubt of airborne sprays blowing back in your eyes - ZAP CANE!!!!!!!!

Noted. I am sure that I will include this in discussions about what is to come. Its always a balance - sometimes (not for the Q series - yet) we have done mixes of frames/completes only to be left with tons of frames at the end that have a hard time selling... some years its the opposite and the...

YIKES! Avoiding dogs is a part of my ride routine but not the snarling type - usually just random ones on super long leashes that seek to jet across the road and clothesline me between them and their owner holding the leash. :(